1. The laying of drag chain cables cannot be twisted, that is, the cables cannot be unrolled from the cable drum or one end of the cable drum. First, spin the reel or cable reel to unwind the cable, and unwind or hang the cable if necessary. The cable used in this case can only be obtained directly from the cable coil.
2. Pay attention to the minimum bending radius of the cable, the installation radius is not less than 6 times the cable diameter.
3. The cables must be laid loosely side by side in the drag chain, separated as much as possible, separated by partitions or inserted into the separation hole of the bracket baffle, the gap between the cables in the drag chain should be at least 10% of the cable diameter.
4. The cables in the drag chain must not touch or get stuck.
5. Both ends of the cable must be fixed, or at least fixed to the mobile end of the drag chain. Generally, the distance between the moving point of the cable and the end of the drag chain should be 20-30 times the diameter of the cable.
6. Please make sure that the cable is moved completely within the bending radius, that is, it must not be moved forcibly. In this way, the cables can be moved relative to each other or towards the device. After running for a period of time, it is best to check the position of the cable. This check must be carried out after the push-pull movement.
7. When the drag chain breaks, the cable also needs to be replaced. Excessive stretch damage is inevitable.
Contact us to discuss your requirements of 12V 150Ah Front Terminal Sealed Lead Acid Battery, 12 volt deep cycle agm battery, Features Of Sealed Lead Acid Batteries. Our experienced sales team can help you identify the options that best suit your needs.